[NC] - Chromo hp dana 44 and 9". 4.56 gears, lockrite, etc.

[braxton357]

78 f150 dana 44. New calipers, hubs, rotors, and pads. BTF cover, DOM tie rod and chromo heims for the steering. Will sell as is with stock welded 3.54 carrier and gears (not installed) and spicer shafts with new spicer joints for $450obo.

Will throw in a set of radius arms too. Or if you want, my set of Lengthened/wristed/bent for tire clearance radius arms.

Also have a set of never used
Alloy usa shafts with yukon chromo joints installed,
billet BC broncos spicer hub lockout centers,
new carrier with new lockrite installed,
new yukon 4.56 gearset and master install kit.

Will sell this stuff and axle for $1200 or will sell this stuff separate for $850

Also have the ford f150 width big bearing 9" rear. Brakes are taken off and have all of the parts to rebuild stock brakes, but was planning on switching to discs. Also have the discs to use (but no calipers). Comes with stock 3.50 gears and carrier with stock 31 spline shafts for $150

or can get it with
uninstalled full spool,
4.56 yukon gears/master install kit and
chromo 31 spline shafts/new bearings/retainers for $550.

Will throw in a set of ballistic fab coil spring perches or leaf spring perches with the 9".

To be clear, the carrier is out of the 44 right now waiting on the new one and the 3rd and brakes are off of the 9" housing right now.



Will sell it all for 1650. There is well over $2k worth of new aftermarket parts here not including the axles.

[reddiablo99]

you have an pic of the 44?

[h0tr0d18]

I would be interested in the following.

Alloy usa shafts with yukon chromo joints installed,
New carrier with new lockrite installed,

I am pretty sure the carrier will work with my waggy D44 but I am not sure about the shafts. Would you know?

Thanks, Chris

***EDIT*** I would be using the carrier with 5.38 gears

[fred1980]

Interested in the 4.56 gears for the HP D44. Already have an install kit. What's shipping to Campbell, CA 95008.

Thanks.
Fred R.